December 2021 - Public - talk.mikrotik.com.au

Draytek modem firmware update
by Roger Plant 09 Apr '22

09 Apr '22

https://faq.draytek.com.au/2021/11/11/nbn-vdsl2-connection-update/ For those with vigor 130's, etc in front of the Mikrotik. Regards Roger---------------------------- Roger Plant

3 3

Some Mikrotik gear on eBay
by Jason Hecker 10 Dec '21

10 Dec '21

Hi, I have an LHG with an EP06-E module and an LTAP for sale on eBay. Alas they are just kicking around taking up space at the moment. Both have ROS7.1 installed and the EP06-E is in MBIM mode. https://www.ebay.com.au/itm/115125379119 https://www.ebay.com.au/itm/115126893331 Regards, Jason Hecker <https://www.upandrunningtech.com.au/>

1 0

The unicorn is stable apparently
by Andrew Gilbett 08 Dec '21

08 Dec '21

So I guess everyone is busy testing V7.1 (Stable)

5 4

VLANing on a CCR1009
by Christopher Hawker 02 Dec '21

02 Dec '21

Hey folks, I’m currently working with a CCR1009 and a Cisco switching stack. We have 4 VLANs on the network, and if a device is configured on a VLAN it can ping its gateway, however cannot access the internet if a source NAT rule is configured using a specific public IP. If it is configured as a masquerade, it works using the primary IP for outbound NAT. What could I be missing? Thanks, CH Sent from my iPhone

4 3

ether2 not enabled as bridge port
by Karl Auer 01 Dec '21

01 Dec '21

We found that ether2 on a newly installed RB4011 was "not working". Investigation revealed it was not delivering an IP address via DHCP. Further investigation revealed that unlike every other port 3-10 in the bridge, ether2 was disabled. Since the DHCP server is on the bridge interface, devices connected to ether2 are not getting served. /interface bridge port add bridge=bridge1 disabled=yes interface=ether2 add bridge=bridge1 interface=ether3 [etc] I didn't configure this unit. I'm a bit mystified as to why it would have been configured like that. My question is whether I can safely just enable it. I can't see why not, but as it is now in production I thought I would ask the brains trust... Regards, K. -- ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ Karl Auer (kauer(a)nullarbor.com.au) work +61 2 64957435 http://www.nullarbor.com.au mobile +61 428 957160 GPG fingerprint: 9FB6 C08F 91CB 5093 30EF 3E2F 8C94 EEBD 117C 4A10 Old fingerprint: CF68 0C56 EEE4 CC19 28D4 03B3 BCE0 E800 E31F 7254

5 8